Table of Contents
Advertisement
Item
Specify the action to take with a frame that hits this ACE.
•
Permit: The frame that hits this ACE is granted permission for the ACE operation.
Action
•
Deny: The frame that hits this ACE is dropped.
•
Filter: Frames matching the ACE are filtered.
Specify the rate limiter in number of base units. The allowed range is 1 to 16. Disabled
Rate Limiter
indicates that the rate limiter operation is disabled.
Frames that hit the ACE are redirected to the port number specified here. The rate limiter
Port
affects these ports. The allowed range is the same as the switch port number range.
Disabled indicates that the port redirect operation is disabled and the specific port number
Redirect
of Port Redirect cannot be set when action is permitted.
Specify the mirror operation of this port. Frames matching the ACE are mirrored to the
destination mirror port. The rate limiter does not affect frames on the mirror port. The
allowed values are:
Mirror
•
Enabled: Frames received on the port are mirrored.
•
Disabled: Frames received on the port are not mirrored.
The default value is Disabled.
Specify the logging operation of the ACE. Notice that the logging message does not include
the 4 bytes CRC information. The allowed values are:
•
Enabled: Frames matching the ACE are stored in the System Log.
Logging
•
Disabled: Frames matching the ACE are not logged.
Note: The logging feature only works when the packet length is less than 1518 (without
Specify the port shut down operation of the ACE. The allowed values are:
•
Enabled: If a frame matches the ACE, the ingress port is disabled.
Shutdown
•
Disabled: Port shut down is disabled for the ACE.
Note: The shutdown feature only works when the packet length is less than 1518 (without
Counter
The counter indicates the number of times the ACE was hit by a frame.
MAC Parameters
Note: Only displayed when the frame type is Ethernet Type or ARP.
Specify the source MAC filter for this ACE.
SMAC Filter
•
Any: No SMAC filter is specified. (SMAC filter status is don't-care.)
•
Specific: If you want to filter a specific source MAC address with this ACE, choose this
value. A field for entering an SMAC value appears.
When Specific is selected for the SMAC filter, you can enter a specific source MAC address.
SMAC Value
The legal format is xx-xx-xx-xx-xx-xx or xx.xx.xx.xx.xx.xx or xxxxxxxxxxxx (x is a
hexadecimal digit). A frame that hits this ACE matches this SMAC value.
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Configuration | Security | Network | ACL | Access Control List | ACE
VLAN tags) and the System Log memory size and logging rate are limited.
VLAN tags).
Security | Network | ACL | Access Control List
Configuration (Continued)
Configuration Pages - 93
Advertisement
Table of Contents
