Table of Contents
Advertisement
Item
Controls the default DEI value.
All frames are classified to a DEI value.
DEI
If the port is VLAN aware and the frame is tagged, then the frame is classified to the DEI
value in the tag. Otherwise the frame is classified to the default DEI value.
Shows the classification mode for tagged frames on this port.
•
Disabled: Use default CoS and DPL for tagged frames.
•
Enabled: Use mapped versions of PCP and DEI for tagged frames.
Tag Class.
Click the mode in order to configure the mode and/or mapping.
Note: This setting has no effect if the port is VLAN unaware. Tagged frames received on
DSCP Based
Click to enable DSCP Based QoS Ingress Port Classification.
The IP/MAC address mode specifying whether the QCL classification must be based on
source (SMAC/SIP) or destination (DMAC/DIP) addresses on this port. The allowed values
Address
are:
Mode
•
Source: Enable SMAC/SIP matching.
•
Destination: Enable DMAC/DIP matching.
QoS | Port Policing
This page allows you to configure the Policer settings for all switch ports.
Item
Port
Enabled
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Configuration | QoS | Port Classification (Continued)
VLAN unaware ports are always classified to the default CoS and DPL.
Configuration | QoS | Port Policing
The port number for which the configuration below applies.
Controls whether the policer is enabled on this switch port.
QoS | Port Policing
Configuration Pages - 157
Advertisement
Table of Contents
