Table of Contents
Advertisement
Using the Web Interface to Configure the IP Address
You must have the MP1204-XT connected to your network and you may need to change your IP address on
your system before you can telnet into the MP1204-XT.
Note: The default IP address of the MP1204-XT is 192.168.250.250.
1. Open your browser and enter 192.168.250.250.
2. Click Configuration | System | IP.
3. Select the Mode (Host or a Router). In Host mode, IP traffic between interfaces will not be routed. In Router
mode traffic is routed between all interfaces.
Note: Refer to the help or
4. If applicable, select the appropriate DNS option.
5. Enter the IP Address and Mask Length.
6. If desired, add interfaces or IP routes.
7. Click the Save button.
8. Click Maintenance | Configuration | Save startup-config.
9. Click the Save Configuration button.
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
System | IP
on Page 38 for more information about the options on this page.
Using the Web Interface to Configure the IP Address
Configuring the IP Address - 31
Advertisement
Table of Contents
