Comtrol RocketLinx MP1204-XT User Manual page 169

Item Configuration | QoS | QoS Control List | QCE Configuration (Continued)
Frame Type can have any of the following values:
•
•
•
•
•
•
•
•
Key
parameters
•
(Continued)
•
•
•
•
•
•
•
•
CoS Class of Service: (0-7) or Default.
DP Drop Precedence Level: (0-1) or Default.
DSCP DSCP: (0-63, BE, CS1-CS7, EF or AF11-AF43) or Default PCP (0-7) or Default.
Action
PCP and DEI cannot be set individually.
Parameters
DEI (0-1) or default.
Policy ACL Policy number (0-255) or Default (empty field).
Default means that the default classified value is not modified by this QCE.
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Any: Allow all types of frames.
EtherType: Ether Type Valid Ether Type can be 0x600-0xFFFF excluding
0x800(IPv4) and 0x86DD(IPv6) or Any.
LLC: SSAP Address Valid SSAP (Source Service Access Point) can vary from 0x00 to
0xFF or Any.
DSAP Address Valid DSAP (Destination Service Access Point) can vary from 0x00 to
0xFF or Any.
Control Valid Control field can vary from 0x00 to 0xFF or Any.
SNAP:PID Valid PID(a.k.a Ether Type) can be 0x0000-0xFFFF or Any.
IPv4: Protocol IP protocol number: (0-255, TCP or UDP) or Any.
Source IP Specific Source IP address in value/mask format or Any. IP and Mask are in
the format x.y.z.w where x, y, z, and w are decimal numbers between 0 and 255.
When Mask is converted to a 32-bit binary string and read from left to right, all bits
following the first zero must also be zero. If a port is configured to match on DMAC/
DIP, this field is the Destination IP address.
IP Fragment IPv4 frame fragmented option: Yes, No or Any.
DSCP Diffserv Code Point value (DSCP): It can be a specific value, range of values or
Any. DSCP values are in the range 0-63 including BE, CS1-CS7, EF or AF11-AF43.
Sport Source TCP/UDP port:(0-65535) or Any, specific or port range applicable for IP
protocol UDP/TCP.
Dport Destination TCP/UDP port:(0-65535) or Any, specific or port range applicable
for IP protocol UDP/TCP.
IPv6: Protocol IP protocol number: (0-255, TCP or UDP) or Any.
Source IP 32 LS bits of IPv6 source address in value/mask format or Any. If a port is
configured to match on DMAC/DIP, this field is the Destination IP address.
DSCP Diffserv Code Point value (DSCP): It can be a specific value, range of values or
Any. DSCP values are in the range 0-63 including BE, CS1-CS7, EF or AF11-AF43.
Sport Source TCP/UDP port:(0-65535) or Any, specific or port range applicable for IP
protocol UDP/TCP.
Dport Destination TCP/UDP port:(0-65535) or Any, specific or port range applicable
for IP protocol UDP/TCP.
QoS | QoS Control List
Configuration Pages - 169