Command Line Interface (Cli); Interface Connection; Execution Modes - Comtrol RocketLinx MP1204-XT User Manual

Command Line Interface (CLI)

Interface Connection

You can refer to Using the Console Port
Interface
Console
Data bit
Parity
Stop bit
Telnet
SSH

Execution Modes

The CLI contains several execution modes. Users will see different set of commands under different execution
modes. The following table lists all the execution modes and their purposes. When users enter a certain
execution mode, the corresponding mode prompts are displayed automatically on the screen. The mode
prompts of all the execution modes are also listed in the table.
Init Mode
Enable Mode
Config Mode
Alarm Profile Config Mode
Gigabit Interface Config Mode
ACL Profile Config Mode
scheduler Profile Config Mode
Vlan Interface Config Mode
IGMP MVR Profile Config Mode
IGMP ACL Profile Config Mode
RingV2 Group Config Mode
Trunk Group Config Mode
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
on Page 29 for more information.
Baud rate: 115200bps,
8
None
1
Port 23
Port 22 (In Windows, you can run terminal emulator such as PuTTY)
Mode
Parameter
Access Level
Guest >
Guest #
Guest (conf)#
Engineer (alarm-profile-conf)#
Engineer (gigabit-intf-conf)#
Engineer (acl-profile-conf)#
Engineer (sch-profile-conf)#
Engineer (vlan-intf-conf)#
Engineer (igmp-mvr-profile-conf)#
Engineer (igmp-acl-profile-conf)#
Engineer (ring)#
Engineer (trunk-group-conf)#
Prompt
Command Line Interface (CLI) - 269