Table of Contents
Advertisement
Initial Configuration Using NetVision
NetVision is a management utility for the RocketLinx family of switches. You can use NetVision to:
•
Locate RocketLinx switches on the network
•
Open the Web GUI for the RocketLinx
•
Reboot the RocketLinx
•
Load factory defaults
•
Change the IP address information
•
Create and load backup configuration files
•
Upgrade RocketLinx firmware
•
Upload the latest Bootloader
•
Generate NetVision log file
This section discusses the following procedures:
•
Setting Up NetVision
•
NetVision Overview
on Page 12
•
Programming Network Information
•
Upgrading Firmware
•
Upgrading the Bootloader
Optionally, you can use the web interface or the CLI to configure the RocketLinx ES7506:
•
Configuration Using the Web Interface
•
Configuration Using the Command Line Interface (CLI)
Setting Up NetVision
Use the following procedure to set up NetVision.
1.
If necessary, install the latest version of the
2.
Copy NetVision into a host system with a Windows operating system. Make sure that you note the file location because
NetVision is an executable and it is not available through the Start button. For your convenience, you may want create a
NetVision shortcut on your desktop.
NetVision is available on the RocketLinx Software and Documentation CD or you can download NetVision from the
ES7506 Software page on the
3.
Start NetVision.
Initial Configuration Using NetVision
on Page 14
on Page 15
on Page 15
on Page 17
Java Runtime
Comtrol FTP site
on Page 21
Environment.
.
RocketLinx ES7506 User Guide: 2000529 Rev. E - 11
Advertisement
Table of Contents
