Table of Contents
Advertisement
Using Telnet to Configure the IP Address
9. Enter ip address ###.###.###.### ###.###.###.### (the IP address – space – subnet mask) and press the Enter
key.
10. Enter exit and press the Enter key.
11. Enter exit and press the Enter key.
12. To save the IP address to the flash, enter copy running-config startup-config and press the Enter key.
You can now open the MP1204-XT web interface to configure it for your environment.
Using Telnet to Configure the IP Address
You must have the MP1204-XT connected to your network and you may need to change your IP address on
your system before you can telnet into the MP1204-XT.
Optionally, if you change your system IP address temporarily, you can use the web interface to configure the
IP address
(Using the Web Interface to Configure the IP Address
Note: The default IP address of the MP1204-XT is 192.168.250.250.
1. Open the command prompt and enter telnet 192.168.250.250.
2. Enter admin as the Username
and press the Enter key.
3. Enter admin as the Password
and press the Enter key.
4. Enter enable and press the
Enter key.
5. Enter configure terminal and
press the Enter key.
6. Enter interface vlan 1 and
press the Enter key.
7. Enter ip address
###.###.###.### ###.###.###.###
(the IP address – space –
subnet mask) and press the Enter key.
8. Move the Ethernet cable the appropriate network connection.
9. Close the telnet session.
10. To save the new IP address to the flash,
enter telnet and the new IP address.
11. Enter the Username and Password.
12. Enter copy running-config startup-config
and press the Enter key.
13. If necessary, return your system IP
address.
You can now open the MP1204-XT web
interface to configure it for your environment.
30 - Configuring the IP Address
on Page 31).
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Advertisement
Table of Contents
