Comtrol ROCKETLINX ES8108 Quick Installation Manual
  1. Manuals
  2. Brands
  3. Comtrol Manuals
  4. Switch
  5. RocketLinx ES8108
  6. Quick installation manual

Comtrol ROCKETLINX ES8108 Quick Installation Manual

Hide thumbs Also See for ROCKETLINX ES8108:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
ROCKETLINX
ES8108
ES8108/ES8108F/ES8108-XT/ES8108F-XT
QUICK INSTALLATION GUIDE
2000578 Rev B | Release Date - August 2014

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ROCKETLINX ES8108 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Comtrol ROCKETLINX ES8108

Summary of Contents for Comtrol ROCKETLINX ES8108

  • Page 1 ROCKETLINX ES8108 ES8108/ES8108F/ES8108-XT/ES8108F-XT QUICK INSTALLATION GUIDE 2000578 Rev B | Release Date - August 2014...

  • Page 2: Wiring The Power Inputs

    INTRODUCTION The RocketLinx ES8108 series of industrial Ethernet switches include the following models: • ES8108 with eight 10/100BASE-TX ports • ES8108F with six 10/100BASE-TX and two 100BASE-FX (Single-Mode or Multi-Mode fiber) ports • ES8108-XT with eight 10/100BASE-TX ports and an extended temperature range •...
  • Page 3 WARNING - EXPLOSION HAZARD – Do not disconnect the ES8108-XT or ES8108F-XT unless the power has been removed or the area is known to be non-hazardous. Power Supply AC Power Input 10-60VDC DC Power Input (UL Listed) 10-60VDC Dry Relay PWR2 PWR1 Output...

  • Page 4: Setting The Dip Switch

    WIRING THE ALARM RELAY OUTPUT The ES8108 has a built-in alarm-relay for port link and power events notifications. The relay contacts are normally open and remain open when there is no failure event. The relay contacts close when there is a failure event to notify.

  • Page 5: Mounting The Switch

    MOUNTING THE SWITCH Mount the ES8108 on the DIN rail using the DIN rail clip that is attached to the rear of the unit. Insert the upper end of DIN rail clip into the back of DIN rail track from its upper side.
  • Page 6 Optical Fiber Specifications Mode Cable Type Wavelength Transmit Receive Link Distance Power Sensitivity Budget (km) Multi 50/125um 1310nm -20dBm to -31dBm to 11dBm 2km Note 62.5/125um -14dBm 0dBm (below) Single 8-10/125um 1310nm -15dBm to -34dBm to 19dBm 30km -8dBm 8dBm Note: In the IEEE standards, it suggests the available transmission distance is 2km for 62.5/125um fiber optical cable in 1310nm wavelength.

  • Page 7: Led Indicators

    LED INDICATORS There are system diagnostic and Ethernet port LEDs located on the front panel of the ES8108. LED Lit LED Off PWR 1/ PWR 2 Powered No Power Alm (Alarm) Port Link is down or a Not activated power failure event has occured.

  • Page 8: Packet Forwarding Ability

    The ES8108 can examine the specific bits of VLAN Tag and TCP/IP TOS of IPv4 and IPv6. COMTROL CUSTOMER SERVICE You can use one of the following methods to contact Comtrol. Contact Method Web Address or Phone Number Support http://www.comtrol.com/support...

This manual is also suitable for:

Rocketlinx es8108fRocketlinx es8108-xtRocketlinx es8108f-xt

Table of Contents