Table of Contents
Advertisement
The SNMP Trap Configuration page includes the following fields.
Item
Trap Mode
Trap Version
Trap Community
Trap Destination
Address
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Configuration | Security| Switch | SNMP | Trap Configuration
Indicates the SNMP trap mode operation. Possible modes are:
•
Enabled: Enable SNMP trap mode operation.
•
Disabled: Disable SNMP trap mode operation.
Indicates the SNMP trap to the supported version. Possible versions are:
•
SNMP v1: Set the SNMP trap to the supported version 1.
•
SNMP v2c: Set the SNMP trap to the supported version 2c.
•
SNMP v3: Set the SNMP trap to the supported version 3.
Indicates the community access string when sending an SNMP trap packet. The
allowed string length is 0 to 255 and the allowed content is ASCII characters from
33 to 126.
Indicates the SNMP trap destination address. It allows a valid IP address in
dotted decimal notation ('x.y.z.w').
It also allow a valid hostname. A valid hostname is a string drawn from the
alphabet (A-Z, a-z), digits (0-9), dot (.), dash (-). Spaces are not allowed, the first
character must be an alpha character, and the first and last characters must not be
a dot or a dash.
Security | Switch | SNMP | Trap
Configuration Pages - 63
Advertisement
Table of Contents
