Table of Contents
Advertisement
Item
Configuration | IPMC | MLD Snooping | VLAN Configuration (Continued)
Priority of Interface. The allowed range is 0 (best effort) to 7 (highest), default
PRI
interface priority value is 0.
RV (Robustness Variable) allows tuning for the expected packet loss on a link.
RV
The allowed range is 1 to 255, default robustness variable value is 2.
QI (Query Interval) is the interval between General Queries sent by the Querier.
QI
The allowed range is 1 to 31744 seconds, default query interval is 125 seconds.
QRI (Query Response Interval) is the Maximum Response Delay used to calculate the
Maximum Response Code inserted into the periodic General Queries.
QRI
The allowed range is 0 to 31744 in tenths of seconds, default query response interval
is 100 in tenths of seconds (10 seconds).
LLQI (Last Listener Query Interval) is the Maximum Response Delay used to
calculate the Maximum Response Code inserted into Multicast Address Specific
Queries sent in response to Version 1 Multicast Listener Done messages. It is also the
Maximum Response Delay used to calculate the Maximum Response Code inserted
LLQI
into Multicast Address and Source Specific Query messages.
The allowed range is 0 to 31744 in tenths of seconds, default last listener query
interval is 10 in tenths of seconds (1 second).
URI (Unsolicited Report Interval) is the time between repetitions of a node's initial
report of interest in a multicast address.
URI
The allowed range is 0 to 31744 seconds, default unsolicited report interval is 1
second.
Click to add a new MLD VLAN. Specify the VID and configure the new entry and then
click save. The specific MLD VLAN starts working after the corresponding static
VLAN is also created.
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
IPMC | MLD Snooping | VLAN Configuration
Configuration Pages - 129
Advertisement
Table of Contents
