Table of Contents
Advertisement
Configuration | MVR
Item
Specify the Multicast VLAN ID.
MVR VID
Note: MVR source ports are not recommended to be overlapped with management VLAN
The MVR Name is an optional attribute to indicate the name of the specific MVR VLAN.
Maximum length of the MVR VLAN Name string is 16. The MVR VLAN Name can only
MVR Name
contain alphabetic or number characters. When the optional MVR VLAN name is given,
it should contain at least one alphabetic character. The MVR VLAN name can be edited
for the existing MVR VLAN entries or it can be added to the new entries.
Define the IPv4 address as source address used in IP header for IGMP control frames.
The default IGMP address is not set (0.0.0.0).
When the IGMP address is not set, the MP1204-XT uses IPv4 management address of
the IP interface associated with this VLAN.
IGMP Address
When the IPv4 management address is not set, the MP1204-XT uses the first available
IPv4 management address.
Otherwise, the MP1204-XT uses a pre-defined value. By default, this value is
192.168.250.250.
Specify the MVR mode of operation. In Dynamic mode, MVR allows dynamic MVR
Mode
membership reports on source ports. In Compatible mode, MVR membership reports are
forbidden on source ports. The default is Dynamic mode.
Specify whether the traversed IGMP/MLD control frames are sent as Untagged or Tagged
Tagging
with MVR VID. The default is Tagged.
Specify how the traversed IGMP/MLD control frames are sent in prioritized manner.
Priority
The default Priority is 0.
Define the maximum time to wait for IGMP/MLD report memberships on a receiver port
before removing the port from the multicast group membership. The value is in units of
LLQI
tenths of a seconds. The range is from 0 to 31744. The default LLQI is 5 tenths or one-
half second.
When the MVR VLAN is created, select the IPMC Profile as the channel filtering
Interface
condition for the specific MVR VLAN. A summary about the Interface Channel Profiling
Channel
(of the MVR VLAN) is shown by clicking the view button. The profile selected for
Profile
designated interface channel is not allowed to have overlapped permit group address.
You can inspect the rules of the designated profile by using the view button:
Profile
Management
Button
Port
The logical port for the settings.
Click to add a new MVR VLAN. Specify the VID and configure the new entry and then
click Save.
122 - Configuration Pages
Configuration | MVR (Continued)
ports.
List the rules associated with the designated profile.
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Advertisement
Table of Contents
