Table of Contents
Advertisement
VeriPhy
VeriPhy
Press the Start button to run the diagnostics. This takes approximately 5 seconds. If all ports are selected, this
can take approximately 15 seconds. When completed, the page refreshes automatically, and you can view the
cable diagnostics results in the cable status table.
Note: VeriPHY is only accurate for cables of length 7 - 140 meters.
10 and 100 Mbps ports are linked down while running VeriPHY. Therefore, running VeriPHY on a 10 or 100
Mbps management port causes the MP1204-XT to stop responding until VeriPHY is complete.
After pressing the Start button, the following table shows up.
Item
Diagnostics | VeriPHY
Port
The port where you are requesting VeriPHY Cable Diagnostics.
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Diagnostics Pages - 259
Advertisement
Table of Contents
