Table of Contents
Advertisement
Feature Configuration
This section explains how to configure the RocketLinx ES7528 software features. There are four ways to access the
RocketLinx ES7528. For information about accessing a configuration method, see the appropriate subsections.
•
Serial console
(Using the Serial Console
•
Web browser
(Using a Web Interface
•
Telnet
(Using a Telnet Console
This section discusses the configuring these software features:
•
Command Line Interface Introduction
•
on Page 29
Basic Setting
•
on Page 47
Port Configuration
•
Power over Ethernet
•
Network Redundancy
•
on Page 79
VLAN
•
Traffic Prioritization
•
on Page 95
Multicast Filtering
•
on Page 101
SNMP
•
on Page 105
Security
•
on Page 117
Warning
•
on Page 127
Monitor and Diag
•
on Page 136
Device Front Panel
•
on Page 137
Save to Flash
on Page 137
•
Logout
Command Line Interface Introduction
The Command Line Interface (CLI) is the user interface to the RocketLinx ES7528 embedded software. You can view the
system information, show the status, configure the switch, and receive a response back from the system by keying in a
command.
There are several different command modes. Each command mode has its own access ability, available command lines and
uses different command lines to enter and exit. These modes are:
•
on Page 24
User EXEC Mode
•
Privileged EXEC Mode
•
Global Configuration Mode
•
(Port) Interface Configuration
•
(VLAN) Interface Configuration
Refer to
Preparation for Management
Feature Configuration
on Page 19)
on Page 16)
on Page 21)
on Page 58
on Page 69
on Page 88
on Page 24
on Page 25
on Page 26
on Page 27
on Page 15 on Page to access the CLI.
RocketLinx ES7528 Industrial Managed PoE Rack Mount User Guide: 2000509 Rev. A - 23
Advertisement
Table of Contents
