Table of Contents
Advertisement
MVR | SFM Information
Each page shows up to 99 entries from the MVR SFM Information Table, default being 20, selected through
the entries per page input field. When first visited, the page shows the first 20 entries from the beginning of the
MVR SFM Information Table.
The Start from VLAN, and Group Address input fields allows you to select the starting point in the MVR SFM
Information Table. Clicking the Refresh button updates the displayed table starting from that or the closest
next MVR SFM Information Table match. In addition, the two input fields will - upon a Refresh button click -
assume the value of the first displayed entry, allowing for continuous refresh with the same start address.
The
uses the last entry of the currently displayed table as a basis for the next lookup.
When the end is reached the text No more entries is shown in the displayed table. Use the
start over.
Item
VLAN ID
Group
Port
Mode
Source Address
Type
Hardware
Filter/Switch
RocketLinx MP1204-XT User Guide: 2000644 Rev. A
Monitor | MVR | MVR SFM Information
VLAN ID of the group.
Group address of the group displayed.
Switch port number.
Indicates the filtering mode maintained per (VLAN ID, port number, Group
Address) basis. It can be either Include or Exclude.
IP Address of the source. Currently, system limits the total number of IP source
addresses for filtering to be 128. When there is no any source filtering address,
the text None is shown in the Source Address field.
Indicates the Type. It can be either Allow or Deny.
Indicates whether data plane destined to the specific group address from the
source IPv4/IPv6 address could be handled by chip or not.
MVR | SFM Information
button to
Monitor Pages - 229
Advertisement
Table of Contents
