Mitsubishi Electric FR-A820-00046 Instruction Manual page 75

Installation and wiring
When using a single wire or stranded wires without a blade terminal, push the open/close button all
the way down with a flathead screwdriver, and insert the wire.
NOTES When using stranded wires without a blade terminal, twist enough to avoid short circuit with a
nearby terminals or wires.
Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may
cause an inverter damage or injury.
● Wire removal
Pull the wire while pushing the open/close button all the way down firmly with a flathead
screwdriver.
NOTES Pulling out the wire forcefully without pushing the open/close button all the way down may dam-
age the terminal block.
Use a small flathead screwdriver (tip thickness: 0.4 mm/tip width: 2.5 mm).
If a flathead screwdriver with a narrow tip is used, terminal block may be damaged.
Commercially available products (as of January 2015)
Name
Driver
Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may
cause an inverter damage or injury.
FR-A800
Open/close button
Flathead
screwdriver
Open/close button
Flathead
screwdriver
Model Manufacturer
SZF 0-0,4×2,5 Phoenix Contact Co., Ltd.
Fig. 2-30:
Connection of a stranded wire
Fig. 2-31:
Wire removal
Control circuit
I002399E
I002400E
2 - 45