· Adjust any point without application of a voltage (current) between terminals 2 and 5 (4 and 5)
(Frequency setting gain adjustment example)
Screen at power-ON
The monitor display appears.
Changing the operation mode
Parameter setting mode
Calibration parameter selection
Selecting the parameter number
Analog voltage (current) display
Analog voltage (current) adjustment
Tab. 5-158: Bias and gain adjustment without application of an reference signal
By pressing the setting dial after step 6, the present frequency setting bias/gain setting can be
confirmed. Confirmation is not possible after executing step 7.
to choose the PU operation mode. [PU] indicator is lit.
to choose the parameter setting mode. (The parameter number read previously appears.)
C4 (Pr. 903) "Terminal 2 frequency setting gain" for the terminal 1.
C7 (Pr. 905) "Terminal 4 frequency setting gain" for the terminal 4.
to display the analog voltage (current) % currently applied to the terminal 1 (4).
is turned, the gain voltage (current) % currently set to the parameter is displayed.
until the desired gain voltage (current) % is displayed.
to enter the setting. The analog voltage (current) % and
to read another parameter.
to return to the
twice to show the next parameter.
(T) Multi-Function Input Terminal Parameters
5 - 407