Parameter Verification - Mitsubishi Electric FR-A820-00046 Instruction Manual

Hide thumbs Also See for FR-A820-00046:
Table of Contents

Advertisement

Parameters
NOTES
Parameter write error. Perform the operation from step
Appears when parameter copy is performed between inverters FR-A820-03160(55K) or lower
or inverters FR-A840-01800(55K) or lower and inverters FR-A820-03800(75K) or higher or FR-
A840-02160(75K) or higher.
5.18.2

Parameter verification

Whether the parameter settings of inverters are the same or not can be checked.
Copy the parameter settings of the verification source inverter to operation panel according to the procedure on page
5-702.
Move the operation panel to the inverter to be verified.
Screen at power-ON
The monitor display appears.
Parameter setting mode
Press
Selecting the parameter number
Turn
Parameter verification
Turn
Press
verification destination inverter is started. (It takes about 60 seconds to verify all the settings. During verification,
"
If there are different parameters, the different parameter number and "
To continue verification, press
"
Tab. 5-322: Parameter verification
NOTE
The set frequency may be incorrect. To continue verification, press SET key.
FR-A800
appears... Why?
and
are displayed alternately.
When CP and 0.00 flicker alternately, set the Pr. 989 "Parameter copy alarm release" as shown
below (initial value):
Pr. 989 setting Operation
10
Cancels the alarm of FR-A820-03160(55K) or lower and FR-A840-01800(55K) or lower.
100
Cancels the alarm of FR-A820-03800(75K) or higher and FR-A840-02160(75K) or higher.
After setting Pr. 989, perform setting of Pr. 9, Pr. 30, Pr. 51, Pr. 56, Pr. 57, Pr. 61, Pr. 70, Pr. 72, Pr.
80, Pr. 82, Pr. 90 to Pr. 94, Pr. 453, Pr. 455, Pr. 458 to Pr. 462, Pr. 557, Pr. 859, Pr. 860, and Pr. 893
again.
to choose the parameter setting mode. (The parameter number read previously appears.)
to
(parameter copy). Press
to change to setting value "
. Verification of the parameter settings copied to the operation panel and the parameter settings of the
" flickers.)
" and "
" flicker alternately after verification ends.
flickers... Why?
Copying and verifying parameters on the operation panel
Operation
. "
" (parameter copy verification mode).
.
again.
" appears.
" flicker.
5 - 703

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents