Show Vlan - D-Link DGS-1510/ME Series Reference Manual

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
Parameters
<portlist> - Enter a range of ports for which you want ingress checking. The port list is specified by listing the
beginning port number on the Switch, separated by a colon. Then highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port list range are separated by a dash.
all - Specifies all ports for ingress checking.
gvrp_state - Specifies to enable or disable GVRP for the ports specified in the port list.
enable - Specifies that GVRP for the specified ports will be enabled.
disable - Specifies that GVRP for the specified ports will be disabled.
ingress_checking - Specifies to enable or disable ingress checking for the specified port list.
enable - Specifies that ingress checking will be enabled for the specified port list.
disable - Specifies that ingress checking will be disabled for the specified port list.
acceptable_frame - Specifies the type of frame will be accepted by the port. There are two types:
tagged_only - Specifies that only tagged packets can be accepted by this port.
admit_all - Specifies that all packets can be accepted.
pvid - Specifies the PVID of the ports.
<vlanid 1-4094> - Enter the VLAN ID here. The VLAN ID value must be between 1 and 4094.
Restrictions
Only Administrators and Operators can issue this command.
Example
To sets the ingress checking status, the sending and receiving GVRP information:
DGS-1510-28XMP/ME:admin# config port_vlan 1-5 gvrp_state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Command: config port_vlan 1-5 gvrp_state enable ingress_checking enable acceptable_frame
tagged_only pvid 2
Success.
DGS-1510-28XMP/ME:admin#
3-8

show vlan

Description
This command is used to display the vlan information including of parameters setting and operational value.
Format
show vlan {<vlan_name 32>}
Parameters
<vlan_name 32> - (Optional) Enter the VLAN name to be displayed. The VLAN name can be up to 32 characters
long.
27