Honda ACCORD HYBRID 2005 Service Manual page 2035

14. Turn the ignition switch OFF.
15. Reconnect the X M receiver connector B (2P).
16. Disconnect the X M antenna module unit 2P
connector.
17. Turn the ignition switch ON (II).
18. Check for voltage between the X M antenna m o d u l e
unit 2P connector No. 1 terminal and body g r o u n d .
X M A N T E N N A M O D U L E UNIT 2P C O N N E C T O R
Is there 3.0 V or more?
YES—Replace the X M receiver (see page 23-76). •
NO—Replace the antenna lead. •
A u d i o - H V A C D i s p l a y M o d u l e
R e m o v a l / I n s t a l l a t i o n
SRS c o m p o n e n t s are located in this area. Review the
SRS c o m p o n e n t locations (see page 24-11) and the
precautions and procedures (see page 24-13) before
performing repairs or service.
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the dashboard and related
parts.
• Lay a shop t o w e l under the parts w h e n w o r k i n g on
t h e m to protect the face panel f r o m scratches or other
damage.
• Do not w o r k in a dusty or dirty place.
• Discharge static electricity f r o m your body before and
during the work.
• Do not touch the circuit board w i t h y o u r bare hands.
• Do not w o r k w i t h dirty hands.
• Be careful not to fold the flat plate cable.
• Do not touch the terminal connector of the flat plate
cable w i t h your bare hands. (If you have touched it,
w i p e it off thoroughly.)
1. Make sure y o u have the anti-theft codes for the
radio and navigation system, then write d o w n the
audio presets.
2. Remove the upper panel (see page 20-68).
3. Remove the center pocket (see page 20-69).
4. W i t h navigation: Remove the navigation control
unit (see page 23-145)
(cont'd)
23-69