Honda ACCORD HYBRID 2005 Service Manual page 1686

Body Electrical
G e n e r a l T r o u b l e s h o o t i n g I n f o r m a t i o n
• Check for loose retainer (A) and rubber seals (B).
• The backs of some connectors are packed w i t h
dielectric grease. A d d grease if necessary. If the
grease is contaminated, replace it.
• Insert the connector all the w a y and make sure it is
securely locked.
• Position wires so that the open end of the cover faces
d o w n .
(cont'd)
Handling Wires and Harnesses
• Secure wires and w i r e harnesses to the frame w i t h
their respective w i r e ties at the designated locations.
• Remove clips carefully; d o n ' t damage their locks (A).
• Slip pliers (A) under the clip base and t h r o u g h the
hole at an angle, then squeeze the expansion tabs to
release the clip.
A
• After installing harness clips, make sure the harness
doesn't interfere w i t h any m o v i n g parts.
• Keep w i r e harnesses away f r o m exhaust pipes and
other hot parts, f r o m sharp edges of brackets and
holes, and f r o m exposed screws and bolts.
• Seat g r o m m e t s in their grooves properly (A). Do not
leave g r o m m e t s distorted (B).
A B
22-4