Honda ACCORD HYBRID 2005 Service Manual page 2137

Erasing the DTC Memory with HDS
1. Make sure the ignition switch is OFF.
2. Connect the HDS to the DLC (A).
3. Turn the ignition switch ON (II).
4. In the TEST MODE MENU of the HDS, select DTC
CLEAR. This erases the DTC(s).
5. Turn the ignition switch OFF, and wait for
10 seconds.
6. Disconnect the HDS f r o m the DLC.
Erasing the DTC Memory with Manual Mode
Special Tools Required
SCS service connector 07PAZ-0010100
To erase the DTC(s) f r o m the SRS unit, use the HDS or
the f o l l o w i n g procedure.
1. Make sure the ignition switch is OFF.
2. Connect the SCS service connector (A) to the
y e l l o w MES 2P connector (B). Do not use a j u m p e r
wire.
3. Turn the ignition switch ON (II).
4. The SRS indicator comes on for about 6 seconds,
and then goes off. Remove the SCS service
connector f r o m the MES connector (2P) w i t h i n 4
seconds after the indicator goes off.
5. The SRS indicator comes on again. Reconnect the
SCS service connector to the MES connector (2P)
w i t h i n 4 seconds after the indicator comes on.
6. W h e n the SRS indicator goes off, remove the SCS
service connector f r o m the MES connector (2P)
w i t h i n 4 seconds.
7. The SRS indicator blinks t w o times, indicating that
the m e m o r y has been erased.
8. Turn the ignition switch OFF, and wait for
10 seconds.
9. Turn the ignition switch ON (II) again. If the SRS
indicator comes on for 6 seconds, and then goes off,
the system is OK.
(cont'd)
24-25