Honda ACCORD HYBRID 2005 Service Manual page 2251

D r i v e r ' s A i r b a g R e p l a c e m e n t
Removal
1. Disconnect the battery negative cable, and w a i t at
least 3 minutes before beginning work.
2. Remove the access panel (A) f r o m the steering
w h e e l , then disconnect the driver's airbag 4P
connector (B) f r o m the cable reel.
4. Disconnect the horn switch connector (1P), then
remove the driver's airbag (B).
Installation
1. Connect the horn switch connector (1P) (A) to the
driver's airbag.
C
9.8 N m (1.0 k g f m , 7.2 Ibf-ft)
B
\ A \
2. Place the new driver's airbag (B) in the steering
w h e e l , and secure it w i t h new Torx bolts (C).
3. Connect the cable reel to the driver's airbag 4P
connector (A), then install the access panel (B) on
the steering w h e e l .
4. Connect the battery negative cable.
5. After installing the airbag, c o n f i r m proper system
operation:
• Turn the ignition switch ON (II); the SRS indicator
should come on for about 6 seconds and then go
off.
• Make sure the horn button w o r k s .
24-139