Honda ACCORD HYBRID 2005 Service Manual page 2201

DTC 44-11: No Signal f r o m the Right Side
Impact Sensor (first)
DTC 44-12: Short to Ground or Short to
Power/Open in Right Side Impact Sensor
(first)
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead H 07YAZ-S3AA100
1. Erase the DTC m e m o r y (see page 24-25).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on, and is DTC 44-11
or 44-12 indicated?
YES—Go to step 3.
NO—Intermittent failure, system is OK at this t i m e .
Go to Troubleshooting Intermittent Failures
(see page 24-26). If another DTC is indicated, go to
the DTC Troubleshooting Index.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
4. Check the connection between the right floor wire
harness 2P connector and the right side impact
sensor (first).
Is the connection OK?
YES — G o to step 5.
NO—Repair the poor connection and retest. If the
DTC 44-11 or 44-12 is still present, g o t o step 5.
5. Disconnect both seat belt tensioner 4P connectors
(see step 6 on page 24-23).
6. Disconnect the right floor w i r e harness 2P
connector (A) f r o m the right side impact sensor
(first).
7. Disconnect SRS unit connector B (28P) f r o m the
SRS unit (see step 7 on page 24-23).
8. Check resistance between the No. 25 and No. 26
terminals of SRS unit connector B (28P). There
should be an open circuit or at least 1 M S .
S R S UNIT C O N N E C T O R B (28P)
17 18 19
20 21 22 23 24 25
26 27
/
B R N / Y E L LT G R N / R E D
W i r e side of female t e r m i n a l s
Is the resistance as specified?
Y E S — G o t o step 9.
NO—Short in the left floor w i r e harness or right
floor wire harness; replace the faulty harness. •
(cont'd)
24-89