Honda ACCORD HYBRID 2005 Service Manual page 2227

DTC 62-20: Short to Ground in Front
Passenger's Seat Belt Buckle Switch
1. Erase the DTC memory.(see page 24-25).
2. Turn the ignition switch ON (II), then buckle and
unbuckle the front passenger's seat belt several
times.
3. Read the DTC (see page 24-24).
Is DTC 62-20 indicated?
Y E S — G o t o step 4.
NO—Intermittent failure, system is OK at this t i m e .
Go to Troubleshooting Intermittent Failures
(see page 24-26). If another DTC is indicated, go to
the DTC Troubleshooting Index.
4. Turn the ignition switch OFF.
5. Disconnect the front passenger's seat belt buckle
switch 3P connector (A) f r o m the right floor w i r e
harness.
6. Check for continuity between the No. 2 terminal of
the front passenger's seat belt buckle switch 3P
connector and body g r o u n d , and between the No. 3
terminal and body g r o u n d . T h e r e should be no
continuity.
FRONT P A S S E N G E R ' S S E A T B E L T
B U C K L E SWITCH 3P C O N N E C T O R
-EEEL
R E D / B L U
T E F ZT
B L U / R E D
T e r m i n a l side of male t e r m i n a l s
Is there continuity?
YES—Replace the front passenger's seat belt
buckle assembly (see page 24-6). •
N O — G o t o step 7.
(cont'd)
24-115