Honda ACCORD HYBRID 2005 Service Manual page 2194

S R S
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
Check resistance between the No. 16 terminal of
SRS unit connector A (28P) and body g r o u n d , and
between the No. 28 terminal and body g r o u n d .
There should be an open circuit or at least 1 M S .
S R S UNIT C O N N E C T O R A (28P)
W i r e side of f e m a l e t e r m i n a l s
Is the resistance as specified?
Y E S — G o t o step 9.
NO—Short to ground in the dashboard wire
harness or engine c o m p a r t m e n t w i r e harness;
replace the faulty harness. •
9. Reconnect the battery negative cable.
10. Turn the ignition switch ON (II).
11. Check for voltage between the No. 16 terminal of
SRS unit connector A (28P) and body g r o u n d , and
between the No. 28 t e r m i n a l and body g r o u n d .
There should be 1 V or less.
S R S UNIT C O N N E C T O R A (28P)
W i r e side of f e m a l e t e r m i n a l s
Is the voltage as specified?
YES—Go to step 12.
NO—Short to power in the engine c o m p a r t m e n t
w i r e harness or dashboard w i r e harness; replace
the faulty harness. •
12. Turn the ignition switch OFF.
13. Connect the SRS inflator simulator (jumper
connector) and the simulator lead H to the engine
c o m p a r t m e n t w i r e harness 2P connector (A).
/ / / /
07SAZ-TB4011A
07YAZ-S3AA100
24-82