Honda ACCORD HYBRID 2005 Service Manual page 2119

8. Install the buckle in the reverse order of removal,
and note these items:
• A p p l y liquid thread lock to the center anchor bolt
before reinstallation.
• Assemble the washers and collar on the center
anchor bolt as s h o w n .
• Reconnect the negative cable to the battery.
• Move the seat all the w a y f o r w a r d and backward
and c o n f i r m that the seat belt buckle harness is
routed properly.
• If the IMA battery level gauge (BAT) displays no
segments, start the engine, and hold it between
3,500 r p m and 4,000 rpm w i t h o u t load (in Park or
Neutral) until the BAT displays at least three
segments.
• Enter the anti-theft codes for the radio and the
navigation system, then enter the customer's
audio presets.
• Set the clock.
Center anchor b o l t installation
W A V E W A S H E R
T O O T H E D // \ C E N T E R A N C H O R
L O C K W A S H E R / / / \ B O L T
S P R I N G W A S H E R C E N T E R A N C H O R
Rear Seat Belt Replacement
NOTE: Check the rear seat belts for damage, and
replace t h e m if necessary. Be careful not to damage
t h e m during removal and installation.
Rear Seat Belt
1. Remove the rear seat-back and rear seat cushion
(see page 20-95).
2. Remove the center anchor bolt (A).
3. Remove the rear shelf (see page 20-51).
4. Remove the retractor m o u n t i n g bolt (A) and the
retractor bolt (B), then remove the rear seat belt (C)
and retractor (D).
(1.0 kgf-m, 7.2 Ibf-ft)
5. Install the seat belt in the reverse order of r e m o v a l ,
and note these items:
• A p p l y liquid thread lock to the anchor bolt before
reinstallation.
• Check that the retractor locking mechanism
functions as described (see page 24-9).
• Before installing the anchor bolt, make sure there
are no twists or kinks in the rear seat belt.
(cont'd)
24-7