Honda ACCORD HYBRID 2005 Service Manual page 2225

7. Unbuckle the front passenger's seat belt.
Check resistance between the No. 1 and No. 2
terminals of the front passenger's seat belt buckle
switch 3P connector. There should be 0—1 Q,.
Check resistance between the No. 1 and No. 3
terminals of the same connector. There should be
an open circuit or at least I M S .
FRONT P A S S E N G E R ' S S E A T B E L T
B U C K L E SWITCH 3P C O N N E C T O R
BLK
T e r m i n a l side of male t e r m i n a l s
BLK BLU
L
1
2 3
U
U
T e r m i n a l side of male t e r m i n a l s
Are the resistances as specified?
Y E S — G o t o step 8.
NO—Replace the front passenger's seat belt buckle
assembly (see page 24-6), then clear the DTC. •
Check resistance between the No. 1 terminal of the
right floor w i r e harness 3P connector and body
ground. There should be 0—1 Q .
RIGHT FLOOR WIRE H A R N E S S 3P C O N N E C T O R
W i r e side of female t e r m i n a l s
Is the resistance as specified?
Y E S — G o t o step 9.
NO—Open in the right floor w i r e harness or poor
g r o u n d connection at G651 (see page 22-40). If
G651 is OK, replace the right floor w i r e harness. •
9. Disconnect the negative cable f r o m the battery.
10. Disconnect both seat belt tensioner 4P connectors
f r o m the left or right floor w i r e harness (see page
24-23).
11. Disconnect SRS unit connector B (28P) f r o m the
SRS unit (see page 24-23).
(cont'd)
24-113