Honda ACCORD HYBRID 2005 Service Manual page 2150

S R S
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
6. Reconnect the battery negative cable.
7. Erase the DTC m e m o r y .
8. Read the DTC (see page 24-24).
Is DTC 11-11, 11-30, 11-41, or 11-60 indicated?
Y E S — G o t o step 9.
NO—Short in the driver's airbag first or second
inflator; replace the driver's airbag (see page
2 4 - 1 3 9 ) . •
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
10. Disconnect the dashboard w i r e harness 4P
connector (A) f r o m the cable reel.
07XAZ-SZ30100
07SAZ-TB4011A
11. Connect the SRS inflator simulator (2 Q
connectors) and the simulator lead to the
dashboard w i r e harness.
12. Reconnect the battery negative cable.
13. Erase the DTC m e m o r y .
14. Read the DTC.
Is DTC 11-11, 11-30, 11-41, or 11-60 indicated?
Y E S — G o t o step 15.
NO—Short in the cable reel; replace the cable reel
(see page 24-150). •
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
16. Disconnect SRS unit connector A (28P) f r o m the
SRS unit (see step 7 on page 24-23).
17. Disconnect the SRS inflator simulator f r o m the SRS
simulator lead.
18. Connect SRS short cancellers (070AZ-SAA0100) to
No. 7 and No. 8 terminals or No. 1 and No. 2
terminals of the SRS unit connector A (28P)
(see page 24-19).
19. Check resistance between the terminals of the SRS
simulator lead. There should be an open circuit or
at least 1 M Q .
DASHBOARD
WIRE H A R N E S S
4P C O N N E C T O R
07XAZ-SZ30100
Is the resistance as specified?
YES—Faulty SRS unit or poor contact at SRS unit
connector A (28P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 24-153). •
NO—Short in the dashboard w i r e harness; replace
the dashboard wire harness. •
24-38