Honda ACCORD HYBRID 2005 Service Manual page 2187

Hide thumbs Also See for ACCORD HYBRID 2005:
Table of Contents

Advertisement

DTC 34-11: Short to Another Wire in Right
Side Curtain Airbag Inflator
DTC 34-30: Decreased Resistance in Right
Side Curtain Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead E 07XAZ-S1A0200
• SRS short canceller 070AZ-SAA0100
1. Erase the DTC m e m o r y (see page 24-25).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator
stay on, and is DTC
34-11
or 34-30
indicated?
Y E S — G o t o step 3.
NO—Intermittent failure, system is OK at this t i m e .
Go to Troubleshooting Intermittent Failures
(see page 24-26). If another DTC is indicated, go to
the DTC Troubleshooting Index.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
4. Disconnect the right side curtain airbag 2P
connector (A) f r o m the side curtain airbag
subharness (B).
5. Connect the SRS inflator simulator (2 £ 2 connector)
and simulator lead E to the side curtain airbag
subharness.
6. Reconnect the battery negative cable.
7. Erase the DTC m e m o r y .
8. Read the DTC (see page 24-24).
Is DTC 34-11 or 34-30
indicated?
Y E S — G o t o step 9.
NO—Short to another w i r e in the right side curtain
airbag inflator; replace the right side curtain airbag
(see page 24-142). •
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
10. Disconnect SRS unit connector C (16P) f r o m the
SRS unit (see step 7 on page 24-23).
11. Disconnect the SRS inflator simulator f r o m the SRS
simulator lead.
12. Connect SRS short canceller (070AZ-SAA0100) to
the No. 13 and No. 14 terminals of SRS unit
connector C (16P) (see page 24-19).
13. Check resistance between the terminals of the SRS
simulator lead. There should be an open circuit or
at least 1 M Q .
SIDE CURTAIN AIRBAG
S U B H A R N E S S 2P C O N N E C T O R
Is the resistance
as
specified?
YES—Faulty SRS unit or poor contact at SRS unit
connector C (16P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 24-153). •
NO—Short in the side curtain airbag subharness;
replace the side curtain airbag subharness. •
24-75

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents