Honda ACCORD HYBRID 2005 Service Manual page 2087

Mic Level
This diagnostic allows y o u to independently test the
microphone and the TALK and BACK buttons. They are
used to activate the voice control system. The
microphone is located near the map light in the ceiling.
It is directional, and w o r k s best if the voice is c o m i n g
f r o m the drivers seat.
• Press the TALK button on the steering w h e e l , and in a
normal voice say " t e s t i n g ' 7 . The TALK indicator on
the screen should m o m e n t a r i l y become green, and
the text " N o w Recording..." should appear in yellow.
In addition, the Mic Level indicator should on the
screen does not briefly become green, then check the
w i r i n g f r o m the TALK button to the navigation unit. If
there is no " M i c L e v e l " m o v e m e n t w h e n you speak,
then y o u should check the w i r e running f r o m the
microphone to the control unit.
• Press the BACK button on the steering w h e e l . This
should cause the Cancel indicator on the screen to
m o m e n t a r i l y become green. If it does not briefly
change to green, then check the w i r i n g f r o m the
steering wheel BACK button to the navigation unit.
NOTE: The Mic Level indicator must reach the 6th bar
or greater to pass the test.
( M i c L e v e l ) 1 Return |
Mic Level
Steering SW
( Talk ) [Cancel ]
VSP Count
This screen displays the n u m b e r of pulses per
revolution of the tire. This is for factory use only, and
should not be changed.
• "Pulse Count S e t t i n g " should always be set to " A u t o " .
• "VSP C o u n t " should always be " 4 " , and should never
be adjusted or set to any other value.
( V S P C o u n t 1 1 Return |
Pulse Count Setting
j
Auto ||Manual |
VSP Count 4 | - | | + |
t
Set )
H/U T i m e Send
This screen determines whether to automatically send
the navigation t i m e to the upper display. The display
unit connector A (10P) passes this i n f o r m a t i o n to the
subdisplay unit. The navigation t i m e can be f o u n d in
the Setup screen 2 " A d j u s t Time Zone/Clock" setting.
• " H / U Time S e n d " should always be set to " O N " .
NOTE: Selecting " R e s e t " on the Adjust Time Zone/
Clock screen automatically resets this diagnostic
function to " O N " .
I H/U T i m e S e n d
) [ J ^ U J T T ]
H/U Time Send | ON j | OFF |
Set
(cont'd)
23-121