Honda ACCORD HYBRID 2005 Service Manual page 2224

S R S
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
DTC 62-10: Open in Front Passenger's Seat
Belt Buckle Switch
1. Erase the DTC m e m o r y (see page 24-25).
2. Turn the ignition switch ON (II), then buckle and
unbuckle the front passenger's seat belt several
times.
3. Read the DTC (see page 24-24).
Is DTC 62-10 indicated?
Y E S — G o t o step 4.
NO—Intermittent failure, system is OK at this t i m e .
Go to Troubleshooting Intermittent Failures
(see page 24-26). If another DTC is indicated, go to
the DTC Troubleshooting Index.
4. Turn the ignition switch OFF.
5. Disconnect the f r o n t passenger's seat belt buckle
switch 3P connector (A) f r o m the right floor w i r e
harness.
6. Buckle the front passenger's seat belt.
Check resistance between the No. 1 and No. 3
terminals of the front passenger's seat belt buckle
switch 3P connector. There should be 0—1 Q.
Check resistance between the No. 1 and No. 2
terminals of the same connector. There should be
an open circuit or at least 1 M Q .
FRONT P A S S E N G E R ' S S E A T B E L T
B U C K L E SWITCH 3P C O N N E C T O R
BLK
B L U
L b d l
T e r m i n a l side of male t e r m i n a l s
BLK
L_
1 2
3
T e r m i n a l side of male t e r m i n a l s
Are the resistances as specified?
Y E S - G o t o step 7.
NO—Replace the front passenger's seat belt buckle
assembly (see page 24-6), then clear the DTC. •
24-112