Honda ACCORD HYBRID 2005 Service Manual page 2231

DTC 85-61: No Signal from the OPDS Unit
DTC 85-62: Non-stipulated Response Data
NOTE:
• An incorrect OPDS unit can cause DTC 85-63.
• A new (uninitialized) OPDS unit installed w i t h a faulty
sensor can also cause DTC 85-71.
1. Make sure nothing is on the front passenger's seat.
2. Erase the DTC m e m o r y (see page 24-25).
3. Read the DTC (see page 24-24).
Is DTC 85-61 or 85-62 indicated?
Y E S — G o t o step 4.
NO—Intermittent failure, system is OK at this t i m e .
Go to Troubleshooting Intermittent Failures
(see page 24-26). If another DTC is indicated, go to
the DTC Troubleshooting Index.
4. Check the connection between the OPDS unit
harness 8P connector D and the OPDS unit.
Is the connection OK?
Y E S — G o to step 5.
NO—Repair the poor connection and retest. If DTC
85-61 or 85-62 is still present, go to step 5.
5. Turn the ignition switch OFF.
6. Check the No. 10 (7.5 A) fuse in the under-dash
fuse/relay box.
Is the fuse OK ?
Y E S — G o t o step 7.
NO—Replace the fuse, then t u r n the ignition switch
ON (II). If the fuse blows again, check for a short in
the No. 10 (7.5 A) fuse circuit (dashboard w i r e
harness, floor w i r e harness, or OPDS unit
harness). •
7. Disconnect the OPDS unit 8P connector D f r o m the
OPDS unit.
8. Turn the ignition switch ON (II).
9. Check for voltage between the No. 4 terminal of the
OPDS unit 8P connector D and body g r o u n d . There
should battery voltage.
O P D S UNIT 8P C O N N E C T O R D
n S
[ WHT
/ 3 4
/
7 8
W i r e side of female t e r m i n a l s
Is there battery voltage?
Y E S — G o to step 14.
NO—Go to step 10.
10. Turn the ignition switch OFF.
(cont'd)
24-119