Honda ACCORD HYBRID 2005 Service Manual page 2110

Navigation System
F o r c e d S t a r t i n g of D i s p l a y D V D - R O M R e p l a c e m e n t
Special Tools Required
SCS service connector 07PAZ-0010100
1. Connect the SCS service connector (A) to the
navigation service check connector (B) located
under the driver's side dash.
07PAZ-0010100
2. Turn the ignition switch ON (II).
3. Check that the system starts up and then changes
to the " N a v i System Link" screen.
NOTE: If the system fails to display the " N a v i
System Link" screen, refer to No picture is
displayed (see page 23-109).
NOTE: W h e n the DVD-ROM is re-inserted or replaced, a
map match must be done (see page 23-82).
1. Turn the ignition switch ON (II).
2. Open the front cover (A) located center console.
3. Press the EJECT button (B) on the navigation unit
(C).
4. Remove the DVD-ROM.
5. Insert the new DVD-ROM.
6. Close the front cover. Do not turn the ignition
switch OFF until the data is d o w n l o a d e d to the
navigation unit.
NOTE: After servicing, the front cover must be
closed. If you start up the navigation system w i t h
the front cover open, the display w i l l indicate
" N a v i g a t i o n unit door is open or No DVD Disk
installed. Please check s y s t e m . "
23-144