Honda ACCORD HYBRID 2005 Service Manual page 1660

Climate Control
H e a t e r U n i t / C o r e R e p l a c e m e n t
( c o n t ' d )
11. Install the heater core, and the evaporator core in
the reverse order of r e m o v a l .
12. Install the heater unit in the reverse order of
removal, and note these items:
• Do not interchange the inlet and outlet heater
hoses, and install the hose clamps securely.
• Refill the cooling system w i t h engine coolant
(see page 10-6).
• Adjust the heater valve cable (see page 21-90).
• Make sure that there is no coolant leakage.
• Make sure that there is no air leakage.
• Refer to the evaporator core replacement (see
step 7 on page 21-88).
• Reset the power w i n d o w control unit (see page
22-200).
• Enter the anti-theft codes for the radio and the
navigation system, then enter the customer's
audio presets.
• If the IMA battery level gauge (BAT) displays no
segments, start the engine, and hold it between
3,500 rpm and 4,000 r p m w i t h o u t load (in Park or
neutral) until the BAT displays at least three
segments.
H e a t e r V a l v e C a b l e A d j u s t m e n t
1. From under the h o o d , open the cable clamp (A),
then disconnect the heater valve cable (B) f r o m the
heater valve arm (C).
B
2. From under the dash, disconnect the heater valve
cable housing f r o m the cable c l a m p (A), and
disconnect the heater valve cable (B) f r o m the air
mix control linkage (C).
D v The lock tab prevents the
\jy cable f r o m c o m i n g off.
21-90