Honda ACCORD HYBRID 2005 Service Manual page 2129

Wiring Precautions
S o m e of the SRS w i r i n g can be identified by special
y e l l o w outer covering, and the SRS connectors can be
identified by their y e l l o w color.
Observe the instructions.
• Never attempt to modify, splice, or repair SRS w i r i n g .
If there is an open or damage in SRS w i r i n g or
terminals, replace the harness.
• Be sure to install the harness wires so they do not get
pinched or interfere w i t h other parts.
• Make sure all SRS ground locations are clean and
securely fastened for o p t i m u m metal-to-metal
contact. Poor g r o u n d i n g can cause intermittent
problems that are difficult to diagnose.
Precautions for Electrical Inspections
• W h e n using electrical test equipment, insert the
probe of the tester into the w i r e side of the connector.
Do not insert the probe of the tester into the terminal
side of the connector, and do not t a m p e r w i t h the
connector.
• Use a U-shaped probe. Do not insert the probe
forcibly.
• Use specified service connectors in t r o u b l e s h o o t i n g .
Using i m p r o p e r tools could cause an error in
inspection due to poor metal-to-metal contact.
(cont'd)
24-17