Honda ACCORD HYBRID 2005 Service Manual page 2246

S R S
S y m p t o m T r o u b l e s h o o t i n g ( c o n t ' d )
S R S indicator stays on, but no DTCs are
stored
NOTE:
• If y o u cannot retrieve DTCs w i t h the HDS using the
SRS menu m e t h o d , retrieve flash codes w i t h the HDS
in SCS mode.
• A new SRS unit must sense the entire system is OK
before completing its initial self-test. The most
c o m m o n cause of an incomplete self-test is the
failure to replace all deployed parts after a collision,
in particular seat belt tensioners (see page 24-136).
• A battery/system voltage above 15.2 V can cause the
SRS indicator to come on w i t h o u t storing any DTCs.
1. Disconnect the battery negative cable, and w a i t for
3 minutes.
2. Disconnect SRS unit connector A (28P) f r o m the
SRS unit (see step 7 on page 24-23).
3. Remove the gauge control m o d u l e (see page
22-235). Disconnect gauge control module
connector (30P) (A) f r o m the gauge control module.
4. Check resistance between the No. 14 terminal of
gauge control m o d u l e connector (30P) and the
No. 19 terminal of SRS unit connector A (28P).
There should be 1 & or less.
G A U G E C O N T R O L M O D U L E C O N N E C T O R (30P)
1 2 .3 4 5 -.6- 7
> < "
8 9 10
A
12 13 14
15 16 17
A
1.9 20 21
/ X
23 24 25 26 28 29
A
Wire side of f e m a l e t e r m i n a l s
S R S UNIT C O N N E C T O R A (28P)
O
S D A
. 1
2
3
4
O
S D A
/
8, 9
10
A / A
•E
m
A
15 16
17 18 19 22 23 24 25 26 27 28
BLU |
W i r e side of f e m a l e t e r m i n a l s
Is the resistance as specified?
Y E S — G o t o step 5.
NO—Open in the dashboard w i r e harness; replace
the dashboard w i r e harness. •
5. Reconnect the battery negative cable.
24-134