Honda ACCORD HYBRID 2005 Service Manual page 2268

S R S
O P D S U n i t R e p l a c e m e n t
NOTE: Review the seat replacement procedure
(see page 20-80) before doing repairs or service.
Removal
1. Disconnect the battery negative cable, and w a i t at
least 3 minutes before beginning work.
2. Disconnect the passenger's side airbag harness 2P
connector (see step 4 on page 24-22).
3. Remove the passenger's seat assembly (see page
20-80) and seat-back cover (see page 20-89).
4. Remove the cover (A), then disconnect the OPDS
unit 8P connector D and sensor connectors (B) f r o m
the OPDS unit (C).
5. Remove the t w o screws (E) and the OPDS unit.
Installation
1. Place the new OPDS unit (A) on the seat-back frame.
Tighten the t w o screws (B), and connect the OPDS
unit harness 8P connector D and sensor connectors
(C) to the OPDS unit. Reinstall the cover (E).
2. Install the seat-back cover in the reverse order of
removal.
3. Install the seat assembly (see page 20-80), then
connect the side airbag harness 2P connector.
4. Reconnect the battery negative cable.
5. Set the seat-back in the normal position, and make
sure there is nothing on the front passenger's seat.
6. Initialize the OPDS unit (see page 24-26).
7. After installing the OPDS unit, c o n f i r m proper
system operation: Turn the ignition switch ON (II);
the SRS indicator should come on for about
6 seconds and then go off.
24-156