Honda ACCORD HYBRID 2005 Service Manual page 2148

S R S
D T C T r o u b l e s h o o t i n g
DTC 11-10: Open or Increased Resistance in
Driver's Airbag First Inflator
DTC 11-40: Open or Increased Resistance in
Driver's Airbag Second Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC m e m o r y (see page 24-25).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on, and is DTC 11-10
or 11-40 indicated?
Y E S — G o t o step 3.
NO—Intermittent failure, system is OK at this t i m e .
Go to Troubleshooting Intermittent Failures
(see page 24-26). If another DTC is indicated, go to
the DTC Troubleshooting Index.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
4. Disconnect the driver's airbag 4P connector (A)
f r o m the cable reel.
07XAZ-SZ30100
/ 0 7 S A Z - T B 4 0 1 1 A
5. Connect the SRS inflator simulator (2 Q
connectors) and simulator lead F to the cable reel.
6. Reconnect the battery negative cable.
7. Erase the DTC m e m o r y .
8. Read the DTC (see page 24-24).
Is DTC 11-10 or 11-40 indicated?
YES — G o t o step 9.
NO—Open or increased resistance in the driver's
airbag first or second inflator; replace the driver's
airbag (see page 24-139). •
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
10. Disconnect the dashboard w i r e harness 4P
connector (A) f r o m the cable reel.
07XAZ-SZ30100
07SAZ-TB4011A
11. Connect the SRS inflator simulator (2 Q
connectors) and the simulator lead to the
dashboard w i r e harness.
12. Reconnect the battery negative cable.
13. Erase the DTC m e m o r y .
24-36