Honda ACCORD HYBRID 2005 Service Manual page 2265

S R S U n i t R e p l a c e m e n t
Removal
1. Disconnect the battery negative cable, and w a i t at
least 3 minutes before beginning work.
2. Disconnect both seat belt tensioner connectors (see
step 6 on page 24-23).
3. Remove the center console and front panel
(see page 20-62).
4. Remove the center pocket (see page 20-69).
5. Remove the driver's and passenger's center lower
cover (see step 4 on page 20-74).
6. Remove the heater vent ducts (see step 5 on page
20-74).
7. Disconnect the connectors and remove the Torx
bolts (A), then pull out the SRS unit.
A
Installation
1. Install the new SRS unit (A) w i t h Torx bolts (B), then
connect the connectors (C) to the SRS unit; push
t h e m into position until they click.
NOTE: Be sure the SRS unit is sitting squarely
against its bracket before t o r q u i n g the Torx bolts.
B
9.8 N m
(1.0
kgf m, 7.2 Ibf ft)
C
2. Reconnect both seat belt tensioner connectors (see
step 6 on page 24-23).
3. Reconnect the battery negative cable.
4. After installing the SRS unit, c o n f i r m proper system
operation: Turn the ignition switch ON (II); the SRS
indicator should come on for about 6 seconds and
then go off.
5. Install all removed parts.
24-153