Honda ACCORD HYBRID 2005 Service Manual page 2099

GPS icon does not indicate
NOTE:
• Make sure the vehicle is parked outside and away
f r o m buildings.
• Refer to GPS Information (see page 23-116) for
realtime satellite reception display.
1. Check for metallic w i n d o w tint on the windshield
and electronic aftermarket accessories (possibly
hidden) m o u n t e d near the GPS antenna or the
navigation unit.
Is there metallic window tint or electronic
accessories?
Y E S — R e m o v e tint or the accessories and
recheck. •
NO—Go to step 2.
2. Go into the Diagnostic Menu and use the " N a v i
System Link" test (see page 23-109) to check the
GPS antenna.
Is "GPS Ant" icon red?
Y E S — U s e the " N a v i E C U " test under Unit Check
(see page 23-113) to check for a kinked, crushed, or
disconnected GPS antenna w i r e . If necessary, try a
k n o w n - g o o d GPS antenna. If icon is still red,
replace the navigation unit (see page 23-145). •
NO—Check that nothing is blocking the GPS
antenna located under the rear shelf and recheck.
Substitude a k n o w n - g o o d navigation unit (see page
23-145), and recheck. •
Voice guidance cannot be heard
NOTE:
• A l w a y s check the connectors for poor connections or
loose terminals.
• Before t r o u b l e s h o o t i n g , w r i t e d o w n the customer's
audio presets, and get the radio and navigation
system anti-theft codes.
• After t r o u b l e s h o o t i n g , enter the radio and navigation
system anti-theft codes, and the audio presets.
1. Press the display unit SET-UP button.
2. Check the v o l u m e setting for the navigation system.
Is it set to OFF?
Y E S — S e t the v o l u m e to an audible level. •
NO—Go to step 3.
3. Check the radio operation.
Can you hear the radio?
Y E S — G o t o step 4.
NO—Troubleshoot the audio system (see page
2 3 - 1 9 ) . •
4. Go into the Diagnostic Menu and use the " N a v i
System Link" test (see page 23-109) to check the
radio.
Is the "Radio" icon red?
Y E S — T r o u b l e s h o o t the audio system (see page
2 3 - 1 9 ) . •
NO—Go to step 5.
5. Turn the ignition switch OFF.
6. Remove the navigation unit (see page 23-145).
7. Remove the audio-HVAC display module (see page
23-69)
8. Disconnect navigation unit connector B (14P) and
the audio unit connector A (20P).
(cont'd)
23-133