Honda ACCORD HYBRID 2005 Service Manual page 2178

S R S
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
DTC 32-80: Short to Power in Front
Passenger's Side Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead E 07XAZ-S1A0200
1. Erase the DTC m e m o r y (see page 24-25).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on f o r about 6 seconds and
then goes off.
Does the SRS indicator stay on, and is DTC 32-80
indicated?
Y E S — G o t o step 3.
NO—Intermittent failure, system is OK at this t i m e .
Go to Troubleshooting Intermittent Failures
(see page 24-26). If another DTC is indicated, go to
the DTC Troubleshooting Index.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
4. Disconnect the right floor w i r e harness 2P
connector (A) f r o m the front passenger's side
airbag (B).
07XAZ-S1A0200
07SAZ-TB4011A
5. Connect the SRS inflator simulator (2 Q connector)
and simulator lead E to the right floor w i r e harness.
6. Reconnect the battery negative cable.
7. Erase the DTC m e m o r y .
8. Read the DTC (see page 24-24).
Is DTC 32-80 indicated?
Y E S - G o t o step 9.
NO—Short to power in the front passenger's side
airbag inflator; replace the front passenger's side
airbag (see page 2 4 - 1 4 1 ) . •
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
10. Disconnect both seat belt tensioner 4P connectors
(see step 6 on page 24-23).
11. Disconnect SRS unit connector B (28P) f r o m the
SRS unit (see step 7 on page 24-23).
12. Disconnect the SRS inflator simulator f r o m the SRS
simulator lead.
13. Reconnect the battery negative cable.
14. Turn the ignition switch ON (II).
15. Check for voltage between each terminal of the
SRS simulator lead and body g r o u n d . There should
be 0.5 V or less.
RIGHT FLOOR
WIRE H A R N E S S
2P C O N N E C T O R
07XAZ-S1A0200
Is the voltage as specified?
YES—Faulty SRS unit or poor contact at SRS unit
connector B (28P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 24-153). •
N O - G o t o step 16.
24-66