Honda ACCORD HYBRID 2005 Service Manual page 2191

8. Check resistance between the No. 15 terminal of
SRS unit connector A (28P) and body g r o u n d , and
between the No. 27 terminal and body g r o u n d .
There should be an open circuit or at least 1 M Q,.
S R S UNIT C O N N E C T O R A (28P)
B R N / Y E L
W i r e side of female t e r m i n a l s
Is the resistance as specified?
Y E S — G o t o step 9.
NO—Short to g r o u n d in the dashboard w i r e
harness or engine c o m p a r t m e n t w i r e harness;
replace the faulty harness. •
9. Reconnect the battery negative cable.
10. Turn the ignition switch ON (II).
11. Check for voltage between the No. 15 terminal of
SRS unit connector A (28P) and body g r o u n d , and
between the No. 27 terminal and body ground.
There should be 1 V or less.
S R S UNIT C O N N E C T O R A (28P)
B R N / Y E L
(V) (V)
Wire side of female t e r m i n a l s
Is the voltage as specified?
Y E S — G o t o step 12.
NO—Short to power in the engine c o m p a r t m e n t
w i r e harness or the dashboard w i r e harness;
replace the faulty harness. •
12. Turn the ignition switch OFF.
13. Connect the SRS inflator simulator (jumper
connector) and simulator lead H to the engine
c o m p a r t m e n t w i r e harness 2P connector (A).
07YAZ-S3AA100
07SAZ-TB4011A
(cont'd)
24-79