Honda ACCORD HYBRID 2005 Service Manual page 2155

DTC 12-11: Short to Another Wire in Front
Passenger's Airbag First Inflator
DTC 12-30: Decreased Resistance in Front
Passenger's Airbag First Inflator
DTC 12-41: Short to Another Wire in Front
Passenger's Airbag Second Inflator
DTC 12-60: Decreased Resistance in Front
Passenger's Airbag Second Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
• SRS short canceller 070AZ-SAA0100
1. Erase the DTC m e m o r y (see page 24-25).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on, and is DTC 12-11,
12-30, 12-41, or 12-60 indicated?
Y E S — G o t o step 3.
NO—Intermittent failure, system is OK at this t i m e .
Go to Troubleshooting Intermittent Failures
(see page 24-26). If another DTC is indicated, go to
the DTC Troubleshooting Index.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
4. Disconnect the front passenger's airbag 4P
connector (A) f r o m the dashboard w i r e harness.
0 7 S A Z - T B 4 0 1 1 A
0 7 X A Z - S Z 3 0 1 0 0
5. Connect the SRS inflator simulator (2 Q,
connectors) and simulator lead F to the dashboard
wire harness.
6. Reconnect the battery negative cable.
7. Erase the DTC m e m o r y .
8. Read the DTC (see page 24-24).
Is DTC 12-11, 12-30, 12-41, or 12-60 indicated?
YES—Go to step 9.
NO—Short in the front passenger's airbag first or
second inflator; replace the front passenger's
airbag (see page 2 4 - 1 4 0 ) . •
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
10. Disconnect SRS unit connector A (28P) f r o m the
SRS unit (see step 7 on page 24-23).
11. Disconnect the SRS inflator simulator f r o m the SRS
simulator lead.
12. Connect SRS short cancellers (070AZ-SAA0100) to
No. 9 and No. 10 terminals and the No. 3 and No. 4
terminal of the SRS unit connector A (28P)
(see page 24-19).
13. Check resistance between the terminals of the SRS
simulator lead. There should be an open circuit or
at least 1 M Q .
D A S H B O A R D
W I R E H A R N E S S
4P C O N N E C T O R
Is the resistance as specified?
YES—Faulty SRS unit or poor contact at SRS unit
connector A (28P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 2 4 - 1 5 3 ) . •
NO—Short in the dashboard w i r e harness; replace
the dashboard w i r e harness. •
24-43