Honda ACCORD HYBRID 2005 Service Manual page 2149

14. Read the DTC.
Is DTC 11-10 or 11-40 indicated?
YES—Go to step 15.
NO—Open or increased resistance in the cable reel;
replace the cable reel (see page 24-150). •
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
16. Disconnect SRS unit connector A (28P) f r o m the
SRS unit (see step 7 on page 24-23). Do not
disconnect the simulator lead f r o m dashboard w i r e
harness 4P connector.
17. Disconnect the SRS inflator simulator f r o m the SRS
simulator lead.
18. Check the resistance between the terminals of the
SRS simulator lead. There should be 1 £ 2 or less.
DASHBOARD
WIRE H A R N E S S
4P C O N N E C T O R
07XAZ-SZ30100
4 g H HgH
Is the resistance as specified?
YES —Faulty SRS unit or poor contact at SRS unit
connector A (28P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 24-153). •
NO—Open or increased resistance in the
dashboard w i r e harness; replace the dashboard
w i r e h a r n e s s . •
DTC 11-11: Short to Another Wire in Driver's
Airbag First Inflator
DTC 11-30: Decreased Resistance in Driver's
Airbag First Inflator
DTC 11-41: Short to Another Wire in Driver's
Airbag Second Inflator
DTC 11-60: Decreased Resistance in Driver's
Airbag Second Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
• SRS short canceller 070AZ-SAA0100
1. Erase the DTC m e m o r y (see page 24-25).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on, and is DTC 11-11,
11-30, 11-41, or 11-60 indicated?
YES — G o t o step 3.
NO—Intermittent failure, system is OK at this t i m e .
Go to Troubleshooting Intermittent Failures
(see page 24-26). If another DTC is indicated, go to
the DTC Troubleshooting Index.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
4. Disconnect the driver's airbag 4P connector (A)
f r o m the cable reel.
07XAZ-SZ30100
/ 0 7 S A Z - T B 4 0 1 1 A
5. Connect the SRS inflator simulator (2 Q
connectors) and simulator lead F to the cable reel.
(cont'd)
24-37