Honda ACCORD HYBRID 2005 Service Manual page 2152

S R S
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
14. Read the DTC.
Is DTC 11-80 or 11-AO indicated?
Y E S — G o t o step 15.
NO—Short to power in the cable reel; replace the
cable reel (see page 24-150). •
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
16. Disconnect SRS unit connector A (28P) f r o m the
SRS unit (see step 7 on page 24-23).
17. Disconnect the SRS inflator simulator f r o m the SRS
simulator lead.
18. Reconnect the battery negative cable.
19. Turn the ignition switch O N (II).
20. Check for voltage between each terminal of the
SRS simulator lead and body g r o u n d . There should
be 0.5 V or less.
DASHBOARD
Is the voltage as specified?
YES—Faulty SRS unit or poor contact at SRS unit
connector A (28P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 24-153). •
NO—Short to power in the dashboard w i r e
harness; replace the dashboard w i r e h a r n e s s . •
DTC 11-90: Short to Ground in Driver's Airbag
First Inflator
DTC 11-B0: Short to Ground in Driver's
Airbag Second Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC m e m o r y (see page 24-25).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on, and is DTC 11-90
or 11-BO indicated?
Y E S — G o t o step 3.
NO—Intermittent failure, system is OK at this t i m e .
Go to Troubleshooting Intermittent Failures
(see page 24-26). If another DTC is indicated, go t o
the DTC Troubleshooting Index.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
4. Disconnect the driver's airbag 4P connector (A)
f r o m the cable reel.
A
5. Connect the SRS inflator simulator (2 Q,
connectors) and simulator lead F to the cable reel.
6. Reconnect the battery negative cable.
7. Erase the DTC m e m o r y .
24-40