Honda ACCORD HYBRID 2005 Service Manual page 2269

F r o n t I m p a c t S e n s o r R e p l a c e m e n t
Removal
1. Disconnect the battery negative cable, and w a i t at
least 3 minutes before beginning work.
2. Disconnect the driver's airbag 4P connector (see
step 2 on page 24-22), the front passenger's airbag
4P connector (see step 3 on page 24-22), and both
seat belt tensioner 4P connectors (see step 6 on
page 24-23).
3. Remove the front bumper (see page 20-101).
4. Remove the intake air resonator for the left side
sensor (see page 11-383).
5. Disconnect the engine c o m p a r t m e n t w i r e harness
2P connector (A), and using a Torx T30 bit, remove
the t w o Torx bolts (B), then remove the front
impact sensor (C).
4
Installation
1. Install the new front impact sensor w i t h Torx bolts
(A), then connect the engine c o m p a r t m e n t wire
harness 2P connector (B) to the front impact sensor
(C).
2. Reconnect the driver's airbag 4P connector
(see page 24-22), the front passenger's airbag 4P
connector (see page 24-22), and both seat belt
tensioner 4P connectors (see page 24-23).
3. Reconnect the battery negative cable.
4. After installing the front impact sensor, c o n f i r m
proper system operation: Turn the ignition switch
ON (II); the SRS indicator should c o m e on for about
6 seconds and then go off.
5. Install all removed parts.
24-157