Honda ACCORD HYBRID 2005 Service Manual page 2219

7. Unbuckle the driver's seat belt.
Check resistance between the No. 2 and No. 3
terminals of the driver's seat belt buckle switch 3P
connector. There should be 0—1 Q.
Check resistance between the No. 1 and No. 3
terminals of the same connector. There should be
an open circuit or at least 1 M Q .
DRIVER'S S E A T B E L T B U C K L E SWITCH
3P C O N N E C T O R
BLK
Wire side of female t e r m i n a l s
B L U
2rL
BLK
1
2
W i r e side of female t e r m i n a l s
Are the resistances as specified?
Y E S — G o t o step 8.
NO—Replace the driver's seat belt buckle assembly
(see page 24-6), then clear the DTC.B
8. Check resistance between the No. 3 terminal of the
driver's seat w i r e harness 3P connector and body
g r o u n d . There should be 0—1 Q.
D R I V E R ' S S E A T WIRE H A R N E S S 3P C O N N E C T O R
L
1 2 3
U u
"T5-ET
BLK
Terminal side of male t e r m i n a l s
Is the resistance as specified?
Y E S - G o t o step 9.
NO—Open in the driver's seat wire harness or left
floor w i r e harness, or poor g r o u n d connection at
G601 (see page 22-38). If G601 is OK, replace the
faulty harness. •
9. Disconnect the negative cable f r o m the battery.
10. Disconnect both seat belt tensioner 4P connectors
f r o m the left and right floor w i r e harnesses
(see page 24-23).
11. Disconnect SRS unit connector B (28P) f r o m the
SRS unit (see page 24-23).
(cont'd)
24-107