Honda ACCORD HYBRID 2005 Service Manual page 1633

ra
9. Turn the ignition switch ON (II), and check the same
wires for voltage to body g r o u n d .
AUDIO-HVAC DISPLAY PANEL C O N N E C T O R B (16P)
_5Z?
G R N ORN
W i r e side of female t e r m i n a l s
Is there any voltage?
YES—Repair any short to power in the wire(s)
between the audio-HVAC display panel and the
recirculation control motor. This short may also
damage the audio-HVAC display panel. Repair the
short to power before replacing the audio-HVAC
display p a n e l . •
NO—Go to step 10.
10. Turn the ignition switch OFF.
11. Check for continuity between the f o l l o w i n g
terminals of audio-HVAC display panel connector B
(16P) and the recirculation control motor IP
connector.
16P: 7P:
No. 10 No. 5
No. 11 No. 7
AUDIO-HVAC DISPLAY PANEL C O N N E C T O R B (16P)
Wire side of female t e r m i n a l s
1 2 4 6
X
8 10
11
X X
14 15 16
G R N ORN
a) ©
G R N / W H T T
| L T G R N / R E D
R E C I R C U L A T I O N C O N T R O L MOTOR 7P C O N N E C T O R
W i r e side of f e m a l e t e r m i n a l s
Is there continuity?
YES—Check for loose w i r e s or poor connections at
audio-HVAC display panel connector B (16P) and at
the recirculation control m o t o r 7P connector. If the
connections are g o o d , substitute a k n o w n - g o o d
audio-HVAC display panel, and recheck. If the
s y m p t o m / i n d i c a t i o n goes away, replace the
original audio-HVAC display p a n e l . •
NO—Repair any open in the wire(s) between the
audio-HVAC display panel and the recirculation
control motor. •
21-63