Honda ACCORD HYBRID 2005 Service Manual page 2208

S R S
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
DTC 46-11: No Signal f r o m the Right Side
Impact Sensor (second)
DTC 46-12: Short to Ground or Short to
Power/Open in Right Side Impact Sensor
(second)
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead H 07YAZ-S3AA100
1. Erase the DTC m e m o r y (see page 24-25).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on, and is DTC 46-11
or 46-12 indicated?
YES—Go to step 3.
NO—Intermittent failure, system is OK at this t i m e .
Go to Troubleshooting Intermittent Failures
(see page 24-26). If another DTC is indicated, go to
the DTC Troubleshooting Index.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
4. Check the connection between the side curtain
airbag subharness 2P connector and the right side
impact sensor (second).
Is the connection OK?
YES — G o t o step 5.
NO—Repair the poor connection and retest. If the
DTC 46-11 or 46-12 is still present, g o t o step 5.
5. Disconnect the right side curtain airbag 2P
connector and side curtain airbag subharness (see
step 5 on page 24-22).
6. Disconnect the side curtain airbag subharness 2P
connector (A) f r o m the right side impact sensor
(second).
7. Disconnect SRS unit connector C (16P) f r o m the
SRS unit (see step 7 o n page 24-23).
8. Check resistance between the No. 15 and No. 16
terminals of SRS unit connector C (16P). There
should be an open circuit or at least 1 M f i .
S R S UNIT C O N N E C T O R C (16P)
9
10 11 12
13
14 15 16
Y E L / B L K Y E L
Wire side of f e m a l e t e r m i n a l s
Is the resistance as specified?
Y E S - G o t o step 9.
NO—Short in the side curtain airbag subharness;
replace the side curtain airbag subharness. •
24-96