Honda ACCORD HYBRID 2005 Service Manual page 2237

6. Check for voltage between the No. 3 terminal of the
OPDS unit harness 8P connector D and body
g r o u n d . There should be battery voltage.
O P D S UNIT H A R N E S S 8P C O N N E C T O R D
O R N / B L U
3
4
7
8
W i r e side of f e m a l e t e r m i n a l s
Is there battery voltage?
YES—Faulty OPDS unit; replace the OPDS unit
(see page 24-156). •
NO—Go to step 7.
7. Turn the ignition switch OFF.
8. Remove the gauge control m o d u l e (see page
22-235). Disconnect gauge control m o d u l e
connector (30P) (A) f r o m the gauge control module.
9. Check resistance between the No. 3 terminal of the
OPDS unit harness 8P connector D and body
g r o u n d . There should be an open circuit or at least
1 M S .
O P D S UNIT H A R N E S S 8P C O N N E C T O R D
O R N / B L U
/
3
4
i
/
8
i
W i r e side of f e m a l e t e r m i n a l s
Is the resistance as specified?
YES—Replace the gauge control m o d u l e . •
N O — S h o r t to g r o u n d in the OPDS unit harness,
right floor w i r e harness or dashboard w i r e harness;
replace the faulty harness. •
24-125